I've Fixed The Chassis And Bulkhead On My Series Land Rover, But I'm Having Problem Lining Up The Body Panels, Any Ideas?


Answer:
Series Land Rovers were never manufactured to the tolerances of a modern car and so latitude of three eighths of an inch is about commonplace. The other problem is that with a Series Land Rover being in trueness a giant Meccano set, panels, especially old ones, are quite credible to be slightly warped and bent. This is an ever-present danger when having to store body panel during a restoration project.

If you haven't yet welded on the back body-to-chassis brackets, fit a hardtop roof.
With the doors surrounded by place and the back body and windscreen fixed to the hardtop, it should then be possible to get everything technically square. You may have to remove some of the back body to rear cross accomplice bolts to get the adjustment right. When all is welded or bolted on, you can consequently remove the hardtop without any of the main components moving out of alignment.



Resolved Questions:
Where Can I Find An Instruction Manual On A Toyota 6300 3 Thread Overlock...
I need a manual for a Toyota Model 6300 , 3 thread overlock made by the Elite Sewing Machine co. This question have been answered on blurtit click to view it. The link interview has the details to lead...

How Often Should A Water Pump Be Replaced?
On a car with a timing belt that drives the water pump the pump should be relpaced when the belt is. Other than that they solitary need to be replaced when ther is a problem with them.

Feeling My Shifts Threw Gears In 98 Regal. Is It Normal? Or Need Adjustments...
1998 buick regal with 43,289 miles on it and the transmission fluid is bright red near no dirt and its full no leaks. So it looks normal. It shifts good beside no slippage. But my problem is i can feel...